Signs That You Might Need To Contact A Hydraulic Repair Service

If your business uses hydraulic systems to get the job done, you've likely invested a good bit of money into this equipment and have taken steps like regular maintenance work to ensure that everything remains in good condition. Hydraulic systems will develop wear and tear over time, though, despite your best efforts. It's even possible something could just go sideways on you through no fault of your own. There are a variety of situations where your hydraulic systems might stop working properly and you will be in need of repair. Here are some of the different scenarios where you will to contact a local hydraulic repair expert.

Your Hydraulic Fluid Has Changed Color and is Likely Contaminated

Hydraulic fluid that runs throughout the cylinder or the rest of the system during operation typically does a great job of keeping things well-lubricated and reducing wear and tear. But have you glanced at your hydraulic fluid recently and noticed that it is now a different color? One of the more common problems that can require professional repair is if you notice your fluid is now a milk-like color. This usually means that water is present and that's not good. Water can reduce lubricity, which means the fluid simply won't be able to lubricate that well and wear and tear will likely increase. If you notice your hydraulic fluid looks milky or looks different at all compared to normal, you will likely want to get a professional in to drain the entire system, remove any remaining water or moisture and then replace it with fresh hydraulic fluid.

Hydraulic Systems Can Be Loud But Whining, Knocking or Banging Noises Are Not Good

Your hydraulic system likely has a loud hum to it while it's in operation, but if you hear a repeated banging or knocking noise or a loud constant whining on top of what the system normally sounds like, shut down the hydraulics and contact a repair expert. Loud and unexpected noises could be a variety of things, ranging from air bubbles that have gotten into the hydraulic fluid to an internal part coming loose and scraping against other parts.

The Fluid is Too Hot or You Are Noticing Excess Heat in General

Hydraulic systems generate heat while in operation but the reservoir and other parts like a heat exchanger are supposed to keep the heat below a certain temperature. If you can sense that the fluid is hotter than usual or see steam coming out of somewhere it should not be, hit the emergency shut off immediately and contact help. You might need to replace a heat exchanger or figure out why the reservoir is not doing its job efficiently, and those are things best left to a professional.

Contact a company like Certified Products Inc for more information.  


Share